EMX5014C Mix se zesilovačem

EMX5014C
Mixing capability Mixing channels 6 Mono + 2 Stereo +Return
AUX 3 (incl. 1x Effect Send)
MAIN Stereo
Input channel functions CH1-6: HPF, Compressor, 3-band mid-sweep PEQ Insert I/O; CH7-10: HPF, 3 band PEQ; CH11-14: 3 band PEQ
On-board processors 2x SPX, 2x 9-band GEQ, YSProcessing
I/O Mic inputs 8
Phantom power +48V DC; ON/OFF
Line inputs 4x Stereo
Control and others Foot switch
On-board amplifiers Maximum output power @4ohms 500W/ch
Maximum output power @8ohms 370W/ch (100V model), 350W/ch (120V model), 320W/ch (220-240V model)
Output selection 500W, 200W, 75W; L/R, AUX1/MONO, AUX1/AUX2
Total harmonic distortion Less than 0.3%
Frequency response 0, +0, -3dB 20Hz-20kHz
Hum & noise level Equivalent input noise -128dBu
Residual output noise -68dBu (Speaker out); -95dBu (Line out)
Crosstalk -68dB
Protection circuit Load protection Power switch on/off mute, DC-fault (power supply shutdown/manual reset), Clip limiter (≧THD 1%; compression)
Amplifier protection Thermal (heatsink temp ≧90 degrees celsius; output mute/auto reset), Vl limiter (RL ≦2ohms)
Power supply protection Thermal (heatsink temp ≧100 degrees celcius; power supply shutdown/manual reset)
Cooling 2x Variable-speed fan
Power requirements Depend on area of purchase; AC100V, 120V or 220-240V; 50/60Hz
Power consumption 500W
Dimensions W 444mm; 17-1/2in
H 155mm; 6-1/8in
D 493mm; 19-7/16 (12U)
Net weight 10.5kg; 23.2lbs
Accessories Owner’s Manual, AC power cord

Input Characteristics

Input Terminal PAD GAIN Actual Load Impedance For Use with Nominal Input Level Connector
Sensitivity Nominal Max. before clip
CH INPUT A 1-6 0dB -60dB 3kohms 50-600 ohm Mics -80dBu -60dBu -40dBu XLR-3-31 type *
-16dB -36dBu -16dBu +4dBu
26dB -34dB -54dBu -34dBu -14dBu
+10dB -10dBu +10dBu +30dBu
CH INPUT B 1-6 0dB -60dB 10kohms 600 ohm Lines -80dBu -60dBu -40dBu TRS phone jack
-16dB -36dBu -16dBu +4dBu
26dB -34dB -54dBu -34dBu -14dBu
+10dB -10dBu +10dBu +30dBu
ST CH INPUT
7/8-9/10
-60dB 3kohms 50-600 ohm Mics -80dBu -60dBu -40dBu XLR-3-31 typek
-16dB -36dBu -16dBu -10dBu
-34dB 10kohms 600 ohm Lines -54dBu -34dBu -14dBu Phone jack
+10dB -10dBu +10dBu +30dBu
ST CH INPUT
11/12-13/14
-34dB 10kohms 600 ohm Lines -54dBu -34dBu -14dBu Phone jack,
RCA pin jack
+10dB -10dBu +10dBu +30dBu
CH INSERT IN (1-6) - 10kohms 600 ohm Lines -20dBu 0dBu +20dBu Phone jack

* 0dBu= 0.775Vrms

Output Characteristics

Output Terminal Actual Source Impedance For Use with Nominal Output Level Connector
Nominal Max. before clip
ST OUT [L,R] 150ohms 600ohm Lines +4dBu +20dBu TRS phone jack
ST SUB OUT [L,R] 150ohms 600ohm Lines +4dBu +20dBu TRS phone jack
AUX SEND 1,2 150ohms 600ohm Lines +4dBu +20dBu TRS phone jack
EFFECT SEND 150ohms 600ohm Lines +4dBu +20dBu TRS phone jack
CH INSERT OUT 1-6 600ohms 10kohm Lines 0dBu +20dBu TRS phone jack
REC OUT [L,R] 600ohms 10kohm Lines -10dBV +10dBV RCA pin jack
PHONES [L,R] 100ohms 8ohm / 40ohm Lines 1mW / 3mW 20mW / 75mW ST phone jack
SPEAKER OUT 0.1ohms 4ohm Speakers 125W 500W speakON
Phone jack

* 0dBu=0.775Vrms. 0dBV =1.0Vrms